Command Panel Operation; Filter Usage Information; Economical Life Of The Filter - Magmaweld DFM 1000 User Manual

10 Operation
OPERATION
EN
3.1 Command Panel
FILTER INDICATORS
MAIN FILTER
GOOD
1 - On-Off Button (Illuminates when the unit is on.)
2 - Motor - Incorrect Rotation direction (Illuminates when the suction motor is reversed.)
3 - Change Main Filter (Illuminates when the filter is full.)
4 - Main Filter in Good Condition (Illuminates as long as the filter is in a good condition.)

3.2 Filter Usage Information

After a certain number of hours of operation, the filters must be replaced. This is related to the amount

3.2.1 Economical Life of the Filter

of dust, gas and fume production. However, if the filter change signal (3) is received, the filter should be
immediately replaced. Depending on the application, filter exchange may also be required earlier.
Recommended replacement intervals are as follows:
NOTE: All the filters are non-reusable. Manual cleaning may eliminate the filter characteristic.
Contaminants can pose a threat for your health by penetrating into the air.
USER MANUAL | KULLANIM KILAVUZU
ENGINE
INDICATORS
MAIN FILTER WRONG
CHANGE ROTATION
Figure 2 : DFM Model Panel Label
Filter Member
Pre roughing filter
Main Filter
Carbon Filter
START START
STOP STOP
Changing Period
100 hrs
650 hrs
1000 hrs
DFM 1000 - 1250 - 1500
WELDING FUME
EXTRACTION SYSTEM
DFM
www.magmaweld.com