Jeep JUC AS User Manual page 10

JXP
Method:
JUC AS / JAD AS:
• Open the package and remove the upper packaging materials.
• Raise the steering column and insert the handlebars taking care not to damage the buzzer (JE-MO-220008* excluded)
and taking care not to crush the cables.
• Fix the steering column by folding the closing lever.
• Place the hook on the inner side of the steering column and insert the 2 screws (with reduced head) without tightening
them.
• Insert the screw (reduced head) in the first hole on the opposite side of the steering wheel.
• Tighten the 3 screws previously inserted.
• Place the screw-cover plate between the remaining hole and the cover display, insert the screw (large head) and tighten
it as needed in order to not damage the plate.
• Pick up the product from the package, open the kickstand and check for the product stability.
• Check the tyre pressure (see the side of the tyre for the recommended value).
*JUC AS (JE-MO-220008) – buzzer
Electronic buzzer (if present)
USB charging port
(lower side, under the
rubber protection)
Left button:
Press and hold to activate
anti-theft mode.
Charging the device: Insert the USB cable into the charging port (lower side).
4x Handlebar screws
1x Allen Key
1x Battery charger
1x Carry strap
Right button:
Press and hold to deactivate
anti-theft mode.
Central button (Horn):
• Press to ring.
• Press twice quickly to change the
sound.
09
Insert the 4 screws manually
without tightening them, then use
the hex wrench supplied to tighten
them and secure the handlebars.