Table of Contents
Advertisement
Router Installation
1.
Position router bracket and mark hole positions.
Depending on material, drill a pilot hole or use a
bradawl. Mount the router mounting bracket to the
surface using the 2 x No.6 Screws provided.
!
Note: Make sure the 'Maxview Logo' is
horizontal and in the correct orientation.
Please Note:
!
When fitting the Signal Booster and Router, there should be as much distance between the
two units as possible. The TV Coax cable and Router SMA cables should also not be routed
next to each other wherever possible. This will reduce the potential for interference between
the two systems.
✗
2.
Attach the antenna coaxial cables to the top 2
connectors. These are marked 'mobile'. Note the order
of the cables does not matter.
IMPORTANT - To prevent damage take
!
care to ensure the centre pins are
aligned before attaching the connector.
!
✓
13
Advertisement
Table of Contents
