Table of Contents
Advertisement
Application example:
Product contents:
> Antenna Unit
> Handle Assembly
> 50cm Antenna (separate carton)
> Accessory Pack
> LNB Park Plate
> No.10 Screws for plastic (small)
> M4 Screws for Plastic
> Cable Clips
> Aluminium 20mm Tube
Required tools and equipment (not supplied):
> 32mm hole saw
> 2.5mm and 8mm twist drill
> Power Drill
> Hacksaw
> No.2 Phillips screwdriver
> Weather Resistant Elastic Adhesive* and Applicator gun
> Surface Cleaner
> 10mm spanner
Selecting an installation location:
Positioning the Antenna Unit and the Handle Assembly
Decide where you wish to mount your satellite system, taking into account
obstacles both on the roof and inside the vehicle. The system MUST be pointing towards the rear of the vehicle
> Check for obstructions such as roof lights and vents
> Check for electrical cables beneath screw fixing points
> Check the 'F' cables will reach satellite receiver (Maxview can supply extended cables)
> Do not allow the dish to overhang the edge of the vehicle
> Clearance around antenna system when in use is shown with reference
> Ensure adequate clearance of the handle assembly from cupboard doors and light fittings
Page 4
> Steel 4mm Spindle
x 1
x 10
> Self Adhesive Zone Map
x 5
> Compass
x 12
> M5 Washers
x 1
> Hexagonal socket key 4mm
> Deburrer/Round File/Emery paper
> Conduit (recommend method for securing cables)
*Maxview recommends the following adhesives:
> Sikaflex®-512 Caravan
> Geocel® Geobond HM
> Sikaflex®-252
> Sikaflex®-55AT
x 1
x 1
x 1
x 2
I
Advertisement
Table of Contents
