Table of Contents
Advertisement
Fitting F Connector
If you decide to shorten the cable please see below method of preparing cable.
1
Cut cable to required length. Strip
away 12mm of outer insulation.
Gather strands of screening braid,
twist together and wind back
around outer insulation. Cut foil
to be flush with outer insulation.
Using Signal Booster
A
12/24V
C
I
B
Connections & features
A. 12/24V power input
B. On/off power switch
C. Wall fixing hole
Operation
1. Slide power switch to the right. The LED indicator should now be on.
2. Turn the gain control knob clockwise to increase signal strength.
Power source methods
- 12/24V DC (Fused Power Cable included for 12/24V wiring)
- 12/24V DC PSU Output (230V PSU)
10
2
Strip away 10mm of inner
insulation around the inner wire.
Check none of the screening braid
is touching the inner copper wire.
D
E
IN
OUT
G
H
D. Antenna input
E. TV output 1
F. TV output 2
F
F
OUT
C
C
G. Gain control knob
H. Power indicator
3
Cut off inner copper wire to
extend 3mm beyond plug body.
Mounting Option
Can be mounted to vehicle
shelving or side panels using the
2 screws provided.
Note:
Before drilling always check for
hidden electrical wires or
plumbing.
Advertisement
Table of Contents
