Advertisement
Quick Links
Advertisement
Related Manuals for Parkside 312142
Summary of Contents for Parkside 312142
- Page 1 SOLDERING IRON SET PLBS 30 B2 Operation and Safety Notes IAN 312142...
- Page 2 ...
- Page 3 Table of contents Symbols used ......................................1. Introduction ............................2. Technical specifications ........................ Contents ........................................Features ........................................Technical specifications for mod. no. PLBS 30 B2 ....................Scope of use ......................................3. Before use ............................Assembling the soldering stand (fig. A/B) ........................
- Page 4 1. Introduction Congratulations on the purchase of your new product. You have chosen a high quality product with this purchase. These operating instructions form an integral part of this product. They contain important instructions on safety, use and disposal of the product. Please familiarise yourself with all operating and safety instructions before using the product.
- Page 5 Do not expose the soldering iron to moisture or rain. - We recommend that you work in the vicinity of the mains socket so that you can quickly pull the plug from the socket in the event of an emergency. Make sure that the tip is correctly fitted before heating the soldering iron.
- Page 6 2. Technical specifications Contents Soldering iron Soldering stand Soldering iron holder Solder wire • Cleaning sponge • 2 soldering tips (1x pre-assembled) • 4 Woodburning tips Features Soldering stand Pointed soldering tip Cleaning sponge Flat soldering tip Adjustable workpiece holders Universal woodburning tip I Accessory compartment Woodburning tip...
- Page 7 3. Before use Assembling the soldering stand (fig. A/B) • Fit the soldering iron holder (15) to the soldering stand (1). • After sliding the soldering iron holder (15) as far as it will go into the hole (1), turn it clockwise to fix it in place.
- Page 8 4. Using the soldering iron Switching on and off • Connect the soldering iron to the mains to switch it on and to heat it up. • Disconnect the soldering iron from the mains to switch it off and to cool it down. CAUTION DANGER OF BURNS! The soldering iron, the soldering tip and the soldering iron holder remain hot for some time after disconnection from the mains!
- Page 9 Woodburning pen • Firstly, make a sketch of the desired pattern on your workpiece with a pencil or alternatively apply a ready-made template to the workpiece. • Types of wood with smooth surfaces are particularly suitable for marking. • When marking wood with a rough surface, be aware that it can be difficult to guide the tip along the line required.
- Page 10 Troubleshooting Fault Possible cause Troubleshooting Soldering iron does not No power supply. Check that the mains supply heat up. (socket) functions correctly. Ask a competent person for advice if necessary. Mains cable or Have the mains cable replaced plug damaged. by the manufacturer or the manufacturer's representative.
- Page 11 6. Warranty Warranty provided by Walter Werkzeuge Salzburg GmbH Dear customer, This appliance comes with a 3 year warranty from the date of purchase. In case of defects in the product you may be entitled to legal claims against the seller of the product. These legal claims are not restricted by the following warranty.
- Page 12 7. Service Walter Werkzeuge Service Center E-Mail: service@walteronline.com Tel.: 00800 925 837 88 IAN 312142 Supplier: Please note that the following address is not a service centre address. Please contact the above-mentioned service centre first. Walter Werkzeuge Salzburg GmbH Gewerbeparkstr.
- Page 13 Walter Werkzeuge Salzburg GmbH Gewerbeparkstr. 9 5081 Anif, Austria V. 1.0 Last Information Update: 05/2019 IAN 312142...
Need help?
Do you have a question about the 312142 and is the answer not in the manual?
Questions and answers