Advertisement
correct position. The minimum recommended length for the water supply hose is
10 meters (but not more than 25 meters) with a diameter of 12.5 mm to avoid
back pressure and any risk of potential damage to your device. Make sure it can
withstand water and a maximum pressure of 0.3 MPa (3 bar). If you want to
connect your device to other water sources, make sure that the maximum water
inlet pressure is 0.3 MPa (3 bar).
-
Insert one of the nozzles (13 or 14) into the lance (11). Then push the lance into
the gun (10) and turn it to the right to lock it. To remove the nozzle, pull the
locking cover back towards the gun and remove the nozzle.
-
Turn the water supply on. If you use the pressure washer and the water supply is
closed, it will damage the pump.
Turning on
Fully unwind the high-pressure hose from the hose reel (2). At the same time hold it
with the transport handle (1).
Turn the operating switch (5) to the "ON" position
Point the spray gun (11) downwards.
Unlock the locking device (18) of the spray gun (11) and press the trigger (19)
fully.
Turning off
Release the trigger (19) and lock it with the locking system (18).
In case of longer interruptions, the high-pressure cleaner should be switched off
with the operation switch (5). ("OFF")
Detergent tank
The detergent tank (10) allows adding automatically the detergent to the washing
water if needed.
Remove the cap to open the tank (10).
Fill the tank with a maximum of 750 ml of detergent solution.
For the preparation of the detergent solution, follow the instructions or
recommendations of the manufacturer of the product used.
Close the tank (10).
Detergent is added by adjusting the jet nozzle and this can only be done in low
pressure mode.
Advertisement
