Advertisement
Automatic stop of the engine
This high-pressure washer is equipped with an automatic engine stop. If the trigger
(19) of the spray gun is activated during operation, the motor stops automatically. By
pressing the trigger (19) again, the motor restarts. During short work breaks, the
trigger (19) of the spray gun (11) should be locked by the locking system (18) to
prevent unintentional starting of the engine. In case of longer interruptions, the
operation switch (5) should also be set to "OFF".
Use of detergents
This high-pressure washer is suitable for the use of universal cleaning products, for
cars, boats, home and garden, recommended by the manufacturer and approved for
use with high-pressure cleaners (e.g. Kärcher, Mellerud).
The use of other cleaning products or chemicals may interfere with the safety and
functionality of the appliance.
When using cleaning products, the dosing and application instructions of the
manufacturer of cleaning products should be observed.
Do not use aggressive cleaning products.
Consult your specialist dealer for advice on suitable cleaning products.
Before start-up
-
It is recommended that a current protection switch be installed by a specialist at
the electrical connection of the device; this will interrupt the power supply, when
the fault current exceeds 30mA for 30 ms.
-
Slide the hose reel (2) into the support provided from the front, and secure it
with two screws.
-
Install the storage support on the right side of the machine. It will be used to
install the gun later.
-
Push the end of the high pressure hose (4) into the high pressure outlet (6) and
screw it on. Push the other end of the high pressure hose into the gun. To remove
the high pressure hose from the gun, press the release button (20) and remove
the hose.
-
Screw the fitting onto the water inlet (7). Push the water hose (or screw it,
depending on the model) onto the fitting. Make sure that the fitting is in the
Advertisement
