Table of Contents
Advertisement
Introduction for buttons on remote controller
Note:
● This is a general use remote controller, it could be used for the air conditioners
with multifunction; For some function, which the model doesn't have, if press
the corresponding button on the remote controller that the unit will keep the
original running status.
● After putting through the power, the air conditioner will give out a sound.
Operation indicator "
using remote controller.
● Under on status, pressing the button on the remote controller, the signal icon "
on the display of remote controller will blink once and the air conditioner will give
out a "di" sound, which means the signal has been sent to the air conditioner.
1
ON/OFF button
Press this button can turn on or turn off the air conditioner. After turning on the air
conditioner, indoor unit will give out a sound.
2
SAVE button
Under cooling mode, press this button to start up or turn off energy-saving function.
When energy-saving function is started up, "SE" will be shown on remote controller,
and air conditioner will adjust the set temperature automatically according to
ex-factory setting to reach to the best energy-saving effect. Press this button again
to exit energy-saving function.
3
FAN button
Pressing this button can set fan speed circularly as: auto (AUTO), low(
(
), high(
Note:
● Under AUTO speed, air conditioner will select proper fan speed automatically
according to ex-factory setting.
● It's Low fan speed under Dry mode.
● Turbo cannot be set in FAN mode.
" is ON. After that, you can operate the air conditioner by
), turbo(
).
Auto
12
"
), medium
Advertisement
Table of Contents
