Page 2
„ O R I G I N A L I N S T R U C T I O N S “ I M P O R T A N T N O T E : Read this manual carefully before installing or operating your new air conditioning unit. Make sure to save this manual for future reference.
Page 3
For downloading manual for this pro- Pro stažení manuálu k tomuto pro- duct, please enter the model name at duktu zadejte modelové označení do this link: následujícího odkazu: Pre stiahnutie manuálu k tomuto pro- Um das Handbuch für dieses Produkt duktu zadajte modelové...
Explanation of Symbols WARNING This symbol indicates the possibility of death or serious injury. This symbol indicates the possibility of injury or damage to CAUTION property. Indicates important but not hazard-related information, used NOTICE to indicate risk of property damage. Exception Clauses Manufacturer will bear no responsibilities when personal injury or property loss is caused by the following reasons.
Safety precautions WARNING Operation and Maintenance tioner to multi-purpose soc- This appliance can be used ket. Otherwise, it may cau- by children aged from 8 se fire hazard. years and above and per- Do disconnect power supp- sons with reduced physi- ly when cleaning air condi- cal, sensory or mental ca- tioner.
Page 6
Safety precautions CAUTION Operation and Maintenance frequently. Do not spill water on the re- Air conditioner gives off mote controller, otherwise burning smell. the remote controller may Indoor unit is leaking. be broken. Do not use fire or hair dry- er to dry the filter to avoid deformation or fire hazard.
Parts name Indoor Unit air inlet panel filter aux. button air outlet horizontal louver If remote controller is lost or damaged, please use aux. button to turn on or turn off the air conditioner. The operation in details is as below: As shown in the figure, open panel and press aux.
Page 8
Parts name Outdoor Unit air inlet air outlet NOTE ● Actual product may be different from above graphics, please refer to actual product.
Operation and introduction of remote controller Introduction for icons on display Buttons on remote controller screen I feel Set fan speed Turbo mode Send signal Auto mode Cool mode Dry mode Fan mode Heat mode Sleep mode 8℃ heating function Health mode Scavenging function Quiet...
button to adjust fan blowing angle. Introduction for buttons on remote controller When selecting dry mode, the air conditioner ● operates at low speed under dry mode. Under NOTE dry mode, fan speed can't be adjusted. ● This is a general use remote controller. It could be Press "...
Page 11
2s later, status will switch to off status directly; if ● Having set X-FAN function on: After turning off the press this button again within 2s, the change of swing unit by pressing " " button indoor fan will continue status will also depend on the circulation sequence stat- running for a few minutes.
Page 12
temperature increased 2 , then the unit will run button at this setting temperature; In Heat mode: sleep status after run for one hour, the setting tem- Press this button to start I FEEL function and " " perature will decrease 1 , two hours, setting will be displayed on the remote controller.
Page 13
NOTE Under heating mode: indoor fan operates at notch 3 ● Under on and off status, you can set TIMER OFF or speed or quiet mode according to the comparison TIMER ON simultaneously. between indoor ambient temperature and set ● Before setting TIMER ON or TIMER OFF, please temperature.
button NOTE ● Under energy-saving function, fan speed is defaulted By pressing this button, you can see indoor set at auto speed and it can't be adjusted. temperature, indoor ambient temperature or out- ● Under energy-saving function, set temperature can't door ambient temperature on indoor unit's display.
NOTICE Temperature display switchover function ● During operation, point the remote control signal Under OFF status, press "▼" and "MODE" buttons sender at the receiving window on indoor unit. simultaneously to switch temperature display ● The distance between signal sender and receiving between °C and °F.
Clean and maintenance WARNING ■ The filter should be cleaned every three months . If there is much dust in the operation environme- WARNING nt, clean frequency can be increased. ■ Turn off the air conditioner and disconnect the ■ After removing the filter, do not touch fins to power before cleaning the air conditioner to av- avoid injury.
Page 17
Checked items before maintenance Phenomenon Solution Check items Whether there’s od- General phenomenon analysis Eliminate the odour Odours are our source, such as source. Clean the Please check below items before asking for furniture and cigare- emitted filter. maintenance. If the malfunction still can’t be tte, etc.
Page 18
Great Britain www.sinclair-world.com This product was manufactured in China (Made in China). R E P R E S E N T A T I V E SINCLAIR Global Group s.r.o. Purkynova 45 612 00 Brno Czech Republic T E C H N I C A L S U P P O R T SINCLAIR Global Group s.r.o.
Page 19
For downloading manual for this pro- Pro stažení manuálu k tomuto pro- duct, please enter the model name at duktu zadejte modelové označení do this link: následujícího odkazu: Pre stiahnutie manuálu k tomuto pro- Um das Handbuch für dieses Produkt duktu zadajte modelové...
Need help?
Do you have a question about the TERREL Series and is the answer not in the manual?
Questions and answers