Belling G755 Installation And User Instructions Manual page 7

Electrical Connection WARNING! THIS APPLIANCE MUST BE EARTHED.
Connection to the electricity supply should be made via a properly earthed,
readily accessible wall socket which is adjacent to and not more than 1.25m
away from the appliance. The socket must be capable of electrical isolation.
The mains lead should be routed such that it cannot touch hot parts of the
cooker i.e. the back panel above a height of 650mm from the floor.
Should this plug not fit the socket outlet in your home it should be cut off and
replaced with a suitable plug as outlined below.
IMPORTANT NOTE: The severed plug cannot be used for any other
appliance and should therefore be properly disposed of in a safe manner.
DO NOT LEAVE where children might find it and plug into a supply socket –
This is an obvious hazard and extremely dangerous.
If the Fitted Plug is The flexible mains lead must be correctly connected as below to a three
Removed pin plug of not less than 13amp capacity. If a BS 1363 plug is used, then
it must be fitted with a 3amp fuse approved to BS 1362.
IMPORTANT: The wires in the mains lead fitted
to this appliance are coloured in
accordance with the following code:
GREEN AND YELLOW – Earth
BLUE
BROWN
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:- The wire which is coloured green and yellow must be
connected to the terminal in the plug marked with the letter 'E' or by the earth
symbol or coloured
The wire coloured blue must be connected to the terminal marked with the
letter 'N' or coloured black. The wire coloured brown must be connected to
the terminal marked with the letter 'L' or coloured red. When wiring the plug,
ensure that all strands of wire are securely retained in each terminal. Do not
forget to tighten the mains lead clamp on the plug. As the appliance must be
earthed, do not use 2-pin socket outlets. If you are in doubt, consult a
qualified electrician.
Should the mains lead ever require replacement, it is essential that this
operation be carried out by a suitably qualified electrician and should only be
replaced with a flexible cord of the same size i.e. 0.75mm² cross sectional
area and temperature rating of 85ºC e.g. heat resisting PVC.
If a Moulded Plug In the event of replacing a fuse in the plug supplied, a 3amp ASTA
is Fitted approved fuse to BS 1362 must be fitted.
NOTE: The fuse cover must be refitted when changing the fuse. In the event
of losing the fuse cover, the plug must not be used until a replacement fuse
cover has been obtained and fitted. A new fuse cover can be obtained from
your local electrical retailer. The colour of the correct replacement fuse cover
is that of the coloured marks or inserts in the base of the plug.
- Neutral
Blue to
- Live
Neutral
Mains Lead Clamp
green or green and yellow.
7
Green &
Yellow to
Earth
Brown to
Live
13 Amp Fuse