Assembling The Pool - Swim & Fun Santorini User Manual

5.

Assembling the Pool

1. Collection of the bottom rails
In the pool area, the profiles are connected into
a round bottom frame (use 14 of the profiles).
Check that the circle is round and correctly placed in rela-
tion to the marking peg used in the base. It is very import-
ant to be certain that the pool liner will subsequently be
correctly positioned (Fig 2).
2. Assembling the Pool Wall
This requires a minimum of two adults, preferably more, as it can be very "tricky" to work with the pool wall at
this point. Therefore, you should never set it up under windy conditions.
Place the pool wall vertically on e.g. a piece of cardboard in the centre of the bottom frame. The wall is rolled
out clockwise and then placed vertically into the bottom rail the entire way around.
NOTE
adjusted on site for the pool wall. You therefore must saw a piece
of the bottom rail off in order to be able to assemble to pool wall.
Exercise caution at this point. Hold off on cutting a correspon-
ding piece of the top rail until the pool is finally assembled.
3. Closing the Pool Wall
You MUST use all the screws and bolts provided. You must not leave any
screw hole in the pool wall empty. Insert the screws from the inside and
tighten them with the washers and nuts on the outside. Place the plastic
caps over the nuts on the outer side of the pool wall.
4. Protection of the Liner
On the inside of the pool, the heads of the screws are covered with
the accompanying liner strip which is taped to the wall in order to
protect the pool liner from wear and tear (Fig. 3).
70
that the length of both the bottom and top rails must be
Fig. 1
Fig. 2
Fig. 3
MV-1942/1943-05-2021 . © All righst reserved Swim & Fun Scandinavia ApS
UK