Warnings And Safety Issues - Coban EDGE Installation Manual

EDGE Installation Manual

Warnings and Safety Issues

Failure to properly install, operate, and care for the COBAN System can increase the risk of ELECTRIC
SHOCK or FIRE. Failure to properly install and secure the COBAN System in accordance with this manual
can increase the risk of any component becoming dislodged from its mounting structure and may possibly
result in SERIOUS INJURY or DEATH to the VEHICLE PASSENGERS, or DAMAGE TO THE COBAN SYSTEM.
Do not expose any Component of the COBAN System to Liquid or Moisture.
Do not install this apparatus near water or expose it to rain, moisture, chemicals, and dripping or splashing
-
liquids of any type
Do not clean the COBAN System with water, liquid cleaners, solvents, or aerosols
-
Prevent the COBAN System from overheating.
Do not block any Ventilation Openings
-
Install in a well ventilated area
-
Do not place the COBAN System near any soft surface that may block ventilation openings
-
Do not install near any heat sources or any apparatus that produces heat
-
Stay away from DANGEROUS VOLTAGE inside the COBAN System; DO NOT take the COBAN System Apart.
Contact with energized parts inside the COBAN System can cause SERIOUS INJURY or DEATH from
-
ELECTRIC SHOCK
Do not attempt to service, modify, repair, or tamper with the COBAN System
-
Refer all Servicing to the COBAN Customer Service Department or COBAN Authorized Service Personnel
-
Avoid damaging any electrical Wires or Cables.
Protect the Cables from being stepped on or pinched, particularly at Plugs, and the point where they exit from
-
the apparatus
Do not jerk, knot, sharply bend, or otherwise abuse the Cables
-
Do not expose Cables or electrical Wiring to sources of Heat
-
When connecting and disconnecting Plugs, PULL ON THE PLUGS, DO NOT PULL ON THE CABLE, and be
-
sure to check the alignment of the Pins for damage prior to plugging them in
Arrange all Connectors and Cables so that passengers are not likely to trip over them or accidently pull on them
-
as they move around, or enter and exit the vehicle
If any Cable or Wire becomes damaged in any way, immediately discontinue use of the COBAN System and call
-
the COBAN Customer Service Department or COBAN Authorized Service Personnel
Only use COBAN approved and authorized Attachments, Accessories, and Peripherals.
Always disconnect the Vehicle Battery Ground Lead prior to installing any Component.
Always remove the fuse at the 12v positive Battery Terminal before Jump-starting or Charging the Battery
while it is still in the Vehicle
The USER acknowledges and understands that the installation of after-market equipment in motor vehicles
can compromise a vehicle's safety-related design characteristics, including but not limited to:
Airbags, including but not limited to potential obstruction of airbag deployment;
-
Front and Rear Passenger compartments, including but not limited to potential for ergonomic problems, physical
-
obstacles, etc.
Trunk/gas tank protection, including but not limited to the potential for trunk-mounted equipment to exacerbate
-
tank vulnerability in a rear collision.
www.cobantech.com Page 4 of 40