Sonance SONAMP A150 Instruction Manual

i n s t r u c t i o n m a n u a l
s o n a m
s u b w o o f e r
introduction
Thank you for purchasing the sonance sonamp
woofer amplifier. This amplifier is specifically designed to be
used with the sonance architectural series™ bps-1 subwoofer,
and when properly installed, the system will give you many
years of entertainment pleasure. To get the most out of your
new amplifier, please read this manual thoroughly before you
begin installation.
To achieve the best performance, sonance recommends that
this amplifier be installed
Dealer/installer.
important safety instructions
basic safety precautions should always be followed when using
your a150 amplifier, to reduce risk of fire, electric shock, and
injury to persons:
1. read and understand all instructions.
2. retain these instructions for future reference.
3. Follow all warnings and instructions in this manual and
marked on the product.
4. any service or repair required must be performed by
qualified factory-authorized personnel.
5. Do not use the amplifier in a high-humidity environment or
near water — for example in a wet basement, or near a wet
bar or swimming pool.
6. always provide adequate ventilation for the amplifier. allow
a minimum of one (1) inch above and three (3)
inches behind the amplifier. Do not block the cooling vents
on the amplifier case.
7. The amplifier should be situated away from heat sources
such as heat registers, radiators, stoves, or other appliances
that produce heat.
8. The amplifier should only be connected to a power supply
of the type marked on its back panel. The power supply
cord should be routed to avoid damage from contact with
sharp objects or being stepped on.
9. unplug the amplifier during thunderstorms or when it will
be unused for extended periods of time.
10. exercise care to avoid spilling liquids on or in the amplifier.
11. Do not place the amplifier on an
unstable table, stand, or cart.
improper placement
amplifier may cause it to fall on an
adult of child causing serious injury,
as well as damage to the amplifier.
12. Do not expose the amplifier to
dripping or splashing. Do not
place objects filled with liquids,
such as vases, on the amplifier.
p a 1
®
a m p l i f i e r
a150 sub-
®
by a sonance authorized
of the
5 0
13. Cleaning: To clean the amplifier, wipe it with a soft cloth.
Do not use solvents, as they may damage the amplifier.
14. non-use periods: unplug the amplifier 's power cord from
the electrical outlet when the woofer will be unused for a
long period of time.
15. Damage requiring service: The amplifier should be
serviced by qualified service personnel when:
a. The power cord or plug has been damaged
b. objects have fallen, or liquids have been spilled into the
amplifier
C. The amplifier has been exposed to rain.
D. The amplifier does not appear to be operating properly
or exhibits a marked change in performance.
e. The amplifier has been dropped or appears to have been
damaged.
16. servicing: The user should not attempt to service the ampli-
fier beyond that described in these instructions. all other
servicing should be referred to qualified service personnel.
17. storms: To prevent damage to components, unplug all
electronic equipment during thunderstorms.
1