Soleus Air KFHHP-12 Manual page 20

Operating Procedures / Photos
Disassemble Motor and Motor Support
Unscrew the four tapping screws fixing the motor,
and remove the motor. Unscrew the two tapping
screws fixing the motor support, and lift the motor
support to remove it.
(refer to Figure 7-20)
Disassemble 4-Way Valve
Screw off the holding nut of the 4-way valve coil
and remove the coil. Use wet cotton cloth to wrap
the 4-way valve, unsold the four soldering points
connecting the 4-way valve, and remove the
4-way valve. Be quick during the unsoldering
process, pay attention to keep the wrapping cloth
wet and do not allow the soldering flame to burn
the compressor lead-out cable.
(Note: only after discharging all freon).
(refer to Figure 7-21)
Disassemble Capillary Subassembly
Unsolder the soldering points connecting the
capillary subassembly and the other pipelines, and
remove the capillary subassembly.
(refer to Figure 7-22)
Motor Support
tapping screws
Motor
4-way valve
soldering points
holding nut
Capillary Subassembly
24
SOLEUSAIR
Figure 7-20
Figure 7-21
Figure 7-22