Soleus Air KFHHP-12 Manual page 13

over the stated value, the compressor will stop, the outdoor fan will delay 30 seconds to stop.
6.1.2.4 FAN mode
In this mode, the indoor fan will run the fan in High, Med, Low and Auto mode. The compressor, outdoor fan
and four-way valve will stop.
In this mode, the temperature setting range is 16~30 .
The unit will adjust the running frequency of the compressor automatically according to the change of ambient
temperature.
6.1.2.5 AUTO mode
In this mode, the system selects COOL, HEAT and FAN mode automatically according to the change of ambient
temperature. The protection function is the same with that of COOL/HEAT mode.
The unit will adjust the running frequency of the compressor automatically according to the change of ambient
temperature.
6.1.3 Other control
6.1.3.1 ON / OFF
Each time the On/Off button of the remote controller is pressed, the On/Off state will switch once.
6.1.3.2 MODE selection
Press the MODE button on the remote controller to select and display the following modes:
AUTO, COOL, DRY, FAN, and HEAT.
6.1.3.3 TEMP. setting button
Each time TEMP + or TEMP - button is pressed, the set temperature will be increased or decreased by 1 .
Adjusting range is 16~30 . In AUTO mode, this button does not function.
6.1.3.4 AUTO key
When the unit is stop, press AUTO key,the unit will run under AUTO mode and the swing motor starts.
When the unit is running, press AUTO key,the unit will be stopped.
6.1.3.5 Timer control
The unit is turned on or off according to the timer set by the remote controller.
6.1.3.6 Sleep control
When the air conditioner is in COOL or DRY mode, after Sleep mode has been set properly, the preset T
be increased by 1
hours. T has been increased by 2
set
the set speed.
When the air conditioner is in HEAT mode, after Sleep mode has been set properly, the preset T
decreased by 1 after the sleep program has run for 1 hour, and T
hours. T has been increased by 2
set
set speed.
In AUTO or FAN mode, the setting temp. will not change.
after the sleep program has run for 1 hour, and T
totally in two hours. Then the unit will run at this set temperature and at
T +1
set
T
set
1 h
totally in two hours. Then the unit will run at this set temperature and at the
1 h
T
set
T
-1
set
will be increased by another 1
set
T +2
set
2 h Above 2h
will be decreased by another 1
set
2 h Above 2h
T
-2
set
17
Set temp.T
set
Set temp.T
set
AUTO/STOP
Handling switch
will
set
after 2
will be
set
after 2