Rear Panel - Inter-m D-6000 Operation Manual

Rear Panel

Rear Panel
1
1. AC POWER INPUT
AC cable input jack. Power rating is AC 220-240V, 50/60Hz (supplied AC mains transformer depends on
country requirements).
2. FAN VENTS
※ note: Do not block the ventilation area.
the air passage way to lower the temperature inside the device.
3. RUN LED
the leD to confirm system's booting status. Upon completion of normal booting leD turn on.
4. WAN PORT
(Web Control Port) Use rJ-45 jack to connect to etHernet terminal to control parameters of the DsP
※ firmware and the operating manual for the GUI, please download from our website(international.inter-m.net/en).
functions. Use DIreCt cable.
[Default Value]
stAtIC IP: 192.168.1.99
GW: 192.168.1.1
sUBnet: 255.255.255.0
5. PRIMARY / SECONDARY DANTE NETWORK PORT
Audinate's DAnte netWork Audio transmission support Port.
Dual network (Primary & secondary) are supported. If problem arises during sending audio signal via the
primary network, the secondary network takes over enabling reliable operation. When after network
recovers from sending the audio signal, network automatically returns to primary network status.
(Default Value : DHCP)
6. RESET SWITCH
factory reset switch. Press and hold for 5 seconds or more to reset all settings back to factory default values.
2
ProfessIonAl netWork AMPlIfIer
3 4 5
/ /
CONTROL
WAN PRIMARY SECONDARY
RUN
7 8
D-6000
6
RST.
5