PublIc Address AMPlIfIer
Rear Panel
Rear Panel
1
1. AC POWER INPUT TERMINAL
It supplies power to this device. The power source is Ac 220 V, 60 Hz. do not bend, pull, twist, heat, or cut
the power cord excessively. It may damage the cord and cause a fire or electric shock.
2. SPEAKER OUTPUT TERMINAL
※ After connecting with the speaker(s), carefully keep them from being overloaded when you use them.
It is a terminal to connect with the speaker(s).
※ You can control the sP 1~5 terminals by using the speaker selection switches in front or the cH 1, 2, 3,
※ before connecting with the speaker(s), unplug the power cord. Then, connect the speaker(s) to use with
4, and 5 buttons of the rM-05A.
※ caution: When installing the system, make sure that the total impedance of the speaker(s) does not fall
the speaker terminal(s) in the rear panel according to the following methods.
below the regulated impedance under all circumstances. Impedance and low output voltage are listed
below.
Model
PAM-312
PAM-324
PAM-336
PAM-348
6
PAM-312/324/336/348
15
2
3
4
5
6
sP1~5/cOM Terminal
100V/84Ω
70V/41Ω
100V/42Ω
70V/21Ω
100V/27.7Ω
70V/13.6Ω
100V/20.8Ω
70V/10.2Ω
14
13
12
11
7
8
How to connect sP 1~5∙cOM
High-Impedance speaker(s)
-
+
10
9
-
+