Cleaning The Body And Control Panel; Cleaning The Water Intake Filters; Draining Remaining Water And Cleaning The Pump Filter - Beko WMB 91242LC User Manual

C
Repeat Drum Cleaning process in every 2 months.
C
Use an anti-limescale suitable for the washing
machines.
After every washing make sure that no foreign
substance is left in the drum.
If the holes on the bellow shown in the figure is
blocked, open the holes using a toothpick.
C
Foreign metal substances will cause rust stains in
the drum. Clean the stains on the drum surface by
using cleaning agents for stainless steel. Never use
steel wool or wire wool.
A
:
Never use sponge or scrub materials.
warning
These will damage the painted and plastic surfaces.

5.3 Cleaning the body and control panel

Wipe the body of the machine with soapy water or
non-corrosive mild gel detergents as necessary, and
dry with a soft cloth.
Use only a soft and damp cloth to clean the control
panel.

5.4 Cleaning the water intake filters

There is a filter at the end of each water intake valve
at the rear of the machine and also at the end of each
water intake hose where they are connected to the
tap. These filters prevent foreign substances and dirt
in the water to enter the washing machine. Filters
should be cleaned as they do get dirty.
1. Close the taps.
2. Remove the nuts of the water intake hoses to
access the filters on the water intake valves. Clean
them with an appropriate brush. If the filters are too
dirty, take them out by means of pliers and clean
them.
3. Take out the filters on the flat ends of the water
intake hoses together with the gaskets and clean
thoroughly under running water.
20 / EN
4. Replace the gaskets and filters carefully in their
places and tighten the hose nuts by hand.
5.5 Draining remaining water and cleaning
the pump filter
The filter system in your machine prevents solid items
such as buttons, coins and fabric fibers clogging the
pump impeller during discharge of washing water.
Thus, the water will be discharged without any
problem and the service life of the pump will extend.
If the machine fails to drain water, the pump filter is
clogged. Filter must be cleaned whenever it is clogged
or in every 3 months. Water must be drained off first to
clean the pump filter.
In addition, prior to transporting the machine (e.g.,
when moving to another house) and in case of freezing
of the water, water may have to be drained completely.
A
:
Foreign substances left in the pump filter
warning
may damage your machine or may cause noise
problem.
In order to clean the dirty filter and discharge the
water:
1. Unplug the machine to cut off the supply power.
A
:
Temperature of the water inside the
warning
machine may rise up to 90 ºC. To avoid burning
risk, filter must be cleaned after the water in the
machine cools down.
2. Open the filter cap.
If the filter cap is composed of two pieces, press the
tab on the filter cap downwards and pull the piece
out towards yourself.
If the filter cap is one piece, pull the cap from both
sides at the top to open.
C
You can remove the filter cover by slightly pushing
downwards with a thin plastic tipped tool, through
the gap above the filter cover. Do not use metal
tipped tools to remove the cover.
3. Some of our products have emergency draining
hose and some does not have. Follow the steps
below to discharge the water.
Discharging the water when the product has an
emergency draining hose:
Washing Machine / User's Manual