Installation - Beko WMB 91242LC User Manual

2 Installation

Refer to the nearest Authorised Service Agent for
installation of the product. To make the product ready
for use, review the information in the user manual
and make sure that the electricity, tap water supply
and water drainage systems are appropriate before
calling the Authorized Service Agent. If they are not,
call a qualified technician and plumber to have any
necessary arrangements carried out.
C
Preparation of the location and electrical, tap
water and waste water installations at the place of
installation is under customer' s responsibility.
Make sure that the water inlet and discharge
hoses as well as the power cable are not folded,
pinched or crushed while pushing the product into
its place after installation or cleaning procedures.
B
WaRNING:
Installation and electrical
connections of the product must be carried out by
the Authorized Service Agent. Manufacturer shall
not be held liable for damages that may arise from
procedures carried out by unauthorized persons.
A
WaRNING:
Prior to installation, visually check
if the product has any defects on it. If so, do not
have it installed. Damaged products cause risks for
your safety.
2.1 appropriate installation location
• Place the machine on a rigid floor. Do not place it on
a long pile rug or similar surfaces.
• Total weight of the washing machine and the dryer
-with full load- when they are placed on top of each
other reaches to approx. 180 kilograms. Place the
product on a solid and flat floor that has sufficient
load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product at places where
temperature may fall below 0ºC.
• Place the product at least 1 cm away from the edges
of other furniture.
2.2 Removing packaging reinforcement
Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement
by pulling the ribbon.
6 / EN
2.3 Removing the transportation locks
A
WaRNING:
Do not remove the transportation
locks before taking out the packaging
reinforcement.
WaRNING:
Remove the transportation safety
bolts before operating the washing machine!
Otherwise, the product will be damaged.
1. Loosen all the bolts with a suitable spanner until
they rotate freely (C) .
2. Remove transportation safety bolts by turning them
gently.
3. Attach the plastic covers supplied in the User
Manual bag into the holes on the rear panel. (P)
C
Keep the transportation safety bolts in a safe place
to reuse when the washing machine needs to be
moved again in the future.
Never move the product without the transportation
safety bolts properly fixed in place!
2.4 Connecting water supply
C
The water supply pressure required to run the
product is between 1 to 10 bars (0.1 – 1 MPa). It is
necessary to have 10 – 80 liters of water flowing
from the fully open tap in one minute to have your
machine run smoothly. Attach a pressure reducing
valve if water pressure is higher.
If you are going to use the double water-inlet
product as a single
must install the supplied stopper to the hot water
valve before operating the product. (Applies for the
products supplied with a blind stopper group.)
Washing Machine / User's Manual
(cold)
water-inlet unit, you