Beko WMB 91242LC User Manual page 21

a. Pull the emergency draining hose out from its seat
b. Place a large container at the end of the hose. Drain
the water into the container by pulling out the
plug at the end of the hose. When the container
is full, block the inlet of the hose by replacing the
plug. After the container is emptied, repeat the
above procedure to drain the water in the machine
completely.
c. When draining of water is finished, close the end by
the plug again and fix the hose in its place.
d. Turn the pump filter to take it out.
Discharging the water when the product does not have
an emergency draining hose:
a. Place a large container in front of the filter to catch
water from the filter.
b. Loosen pump filter (anticlockwise) until water starts
to flow. Fill the flowing water into the container you
have placed in front of the filter. Always keep a piece
of cloth handy to absorb any spilled water.
c. When the water inside the machine is finished, take
out the filter completely by turning it.
4. Clean any residues inside the filter as well as fibers,
if any, around the pump impeller region.
5. Install the filter.
6. If the filter cap is composed of two pieces, close the
filter cap by pressing on the tab. If it is one piece,
seat the tabs in the lower part into their places first,
and then press the upper part to close.
21 / EN
Washing Machine / User's Manual