Maintenance And Cleaning - Beko WMB 91242LC User Manual

To deactivate the Child Lock:
Press and hold 2 and 4
nd
for 3 seconds. "COFF" appears on the display.
C
Do not forget to disable the child lock at the
end of the programme if it was enabled before.
Otherwise, machine will not allow to select a new
programme.
4.18 Cancelling the programme
Press and hold Start / Pause / Cancel button for 3
seconds. Start symbol flashes. Symbol of the step at
which the programme was cancelled remains lit. "End"
appears on the display and the programme is cancelled.
C
If you want to open the loading door after you
have cancelled the programme but it is not
possible to open the loading door since the water
level in the machine is above the loading door
opening, then turn the Programme Selection knob
to Pump+Spin programme and discharge the
water in the machine.
4.19 Machine is in Rinse Hold mode
Spin symbol flashes and Pause symbol illuminates
when the machine is in Rinse Hold mode.
If you want to spin your laundry when the machine is
in this mode:
Adjust the spin speed and press Start / Pause / Cancel
button. Pause symbol disappears and Start symbol
appears. Programme resumes, discharges the water
and spins the laundry.
If you only want to drain the water without spinning:
Just press Start / Pause / Cancel button. Pause symbol
disappears. Start symbol appears. Programme resumes
and discharges the water only.
4.20 End of programme
"End" appears on the display at the end of the
programme. Symbols of the programme steps remain
lit. Auxiliary function, spin speed and temperature
that were selected at the beginning of the programme
remain selected.
4.21 Your machine is equipped with a
"Standby Mode"
In case of not starting any programme or waiting
without making any other operation when the
machine is turned on by On/Off button and while it is
in selection step or if no other operation is performed
approximately 2 minutes after the programme
you selected has come to an end, your machine
will automatically switch to energy saving mode.
Brightness of indicator lights will decrease. Also, if
your product is equipped with a display showing the
programme duration, this display will completely turn
off. In case of rotating the Programme Selection knob
or pressing any button, lights and display will restore
to their previous condition. Your selections made while
exiting the energy saving mode may change. Check the
appropriateness of your selections before starting the
programme. Readjust if necessary. This is not a fault.
19 / EN
Auxiliary Function buttons
th

5 Maintenance and cleaning

Service life of the product extends and frequently
faced problems decrease if cleaned at regular intervals.
5.1 Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every
4-5 washing cycles) as shown below in order to
prevent accumulation of powder detergent in time.
1. Press the dotted point on the siphon in the softener
compartment and pull towards you until the
compartment is removed from the machine.
C
If more than normal amount of water and
softener mixture starts to gather in the softener
compartment, the siphon must be cleaned.
2. Wash the detergent drawer and the siphon with
plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to
avoid touching of the residues in the drawer with
your skin when cleaning.
3. Insert the drawer back into its place after cleaning
and make sure that it is seated well.
If your detergent drawer is the one indicated in the
following figure:
C
Lift the rear part of the siphon to remove it as
illustrated. After performing the above mentioned
cleaning procedures, replace the siphon back to its
seating and push its front section downwards to
make sure that the locking tab engages.
5.2 Cleaning the loading door and the drum
For products with drum cleaning programme, please
see Operating the product - Programmes.
For products without drum cleaning, follow the below
steps to clean the drum:
Select additional Water or Extra Rinse auxiliary
functions. Use a Cottons programme without
pre-wash. Set the temperature to the level
recommended on the drum cleaning agent which
can be provided from authorized services. Apply
this procedure without any laundry in the product.
Before starting the programme, put 1 pouch of special
drum cleaning agent (if the special agent could not be
supplied, put max. 100 g of powder anti-limescale) into
the main wash detergent compartment (compartment
no. "2"). If the anti-limescale is in tablet form, put only
one tablet into the main wash compartment no. "2".
Dry the inside of the bellow with a clean piece of cloth
after the programme has come to an end.
Washing Machine / User's Manual