5
Troubleshooting > Backup/Restoration by Expansion ROM for servicing and Sublog Board > Backup and Restoration (Export and Import) > Changing the Height of the Sublog Board
Backup and Restoration (Export and Import)
■ Flow of Export and Import
START
After turning OFF the power, install the Sublog Board
attached with the Expansion ROM to the Main
Controller PCB.
Export the data to the Sublog Board.
Has data been exported?
Yes
After turning OFF the power, remove the Sublog Board
and the faulty Main Controller PCB from the machine.
Before installation to the machine, install the Sublog
Board (to which data was exported) attached with the
Expansion ROM to an unused Main Controller PCB.
Install the above unused Main Controller PCB to the
machine and turn ON the power.
Import data from the Sublog Board.
After turning OFF the power, remove the Sublog
Board from the Main Controller PCB.
END
5
Troubleshooting > Backup/Restoration by Expansion ROM for servicing and Sublog Board > Backup and Restoration (Export and Import) > Changing the Height of the Sublog Board
Make settings again manually since
No
data cannot be exported from the faulty
Main Controller PCB.
END
F-5-64
■ Changing the Height of the Sublog Board
NOTE:
When installing the Sublog Board, it needs to be installed parallel to the Main Controller
PCB in order to prevent connection error of the connector connecting the Main
Controller PCB and the Sublog Board.
This machine utilizes the height of the spacer (short), and how to replace the spacers
with each other is shown below.
2) Disassemble the Sublog Board [1], and replace the spacer (short) [1] and the spacer (long)
[3] with each other.
• 1 screw [4]
CAUTION:
Because the screw [4] is a molded part, do not tighten it too much. Otherwise, it may be
damaged.
[1]
5-61
[4]
[3]
[2]
F-5-65
5-61