Led Code Chart; Maintenance And Chemicals - Intex PureSpa SB-HSWF10 Owner's Manual

LED Reading
001H-008H
E81
E90
E91
E92
E94
E95
E96
E97
E99
END
BLANK

MAINTENANCE AND CHEMICALS

Always unplug this product from the electrical outlet before removing, cleaning, servicing or
making any adjustment to the product.
Water Sanitation
The spa owner must regularly check and keep the spa water sanitized with scheduled maintenance (daily, if
necessary). Adding sanitizer and other chemical will control bacteria and viruses present in the spa water.
The maintenance of a proper water balance through appropriate use of sanitizers is the single most important
factor in maximizing the life and appearance of the spa tub as well as ensuring clean, healthy and safe water.
Proper technique is important for water testing and treating the spa water. See your pool/spa professional for
chemical, sanitizer, test kits and testing procedures questions.
CAUTION: ALWAYS FOLLOW THE CHEMICAL MANUFACTURER'S DIRECTIONS, AND
THE HEALTH AND HAZARD WARNINGS.
Do not add chemicals if the spa is occupied. This can cause skin or eye irritation. Concentrated chlorine
solutions can damage the spa tub. In no event is Intex Recreation Corp., Intex Development Co. Ltd., their
related companies, authorized agents and service centers, retailers or employees liable to the buyer or any
other party for costs associated with the loss of spa water, chemicals or water damage.
S AVE THESE INSTRUCTIONS
(353PO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 02/03/2023

LED CODE CHART

Operating Hours (1-8 hours remaining)
Transmission signal failure
Alarm Code (Low Salt Level)
Alarm Code (High Salt Level)
Water temperature too low
Water temperature too high
Dry-fi re Protection
Water temperature sensor broken
After 72 hours of continuous heating operation, the pump will hibernate
automatically. The rapid heating function is disabled.
Control panel battery has no power, place the control panel back on the
control base charging dock to charge the battery and reactivate.
WARNING
Defi nitions
No water fl ow
System Error
353
English
PO
Page 21