Intex PureSpa SB-HSWF10 Owner's Manual page 11

Release Air
For Spa Tub Wall:
1. With the spa control unit attached to the spa tub, turn the air
passage selection dial on the side of the control base to "
defl ate position (see drawing 11).
2. Press the air bubble
3. When defl ation is completed, turn the air passage selection dial
back to " " bubble position and press the
turn it off .
To defl ate the spa tub for storage, see "STORAGE" section.
For Cover Air Bladder:
1. Pull the valve cap out and squeeze the valve at its base to release
a small amount of air.
2. Close and recess the valve back.
To defl ate the cover air bladder for storage, see "STORAGE" section.
Accesories assembly and water fi lling
1. Attach the two fi lter cartridge housing assemblies to the two outlet
grids on the inside of the spa (lower position). Infl ate the spa tub fi rst
before installing fi lter pump fi ttings.
ATTENTION! In order to comply with the requirements of the Virginia
Grahame Baker Act, suction outlets cannot be covered while the
spa is in use. The Act was intended to address high suction/volume
circulation systems but does not exclude low volume systems as
used on this spa. Accordingly, remove the fi lter cartridge assemblies
and any other spa cleaning attachment from the spa outlets before
spa usage (see drawing 13).
Re-attach them after usage for water fi ltration and cleaning.
2. Before fi lling with water ensure the bottom drain valve caps are
securely closed on the inside and outside.
3. Fill the spa tub with freshwater to a level between MIN and MAX
marked on the inside of the spa wall. Do not over fi ll the spa. Never move the spa tub with water inside
and/or with the control base attached to the spa as the spa or control base may be damaged.
WARNING: Never pour water with a temperature higher than 104°F (40°C) into
the spa directly. It is recommended to fi ll the spa tub with lukewarm water for quick
heating and energy saving.
4. Insert infl ated bladder in the spa tub fl ush with the top of the tub. Cover the entire spa with the Outer
Foam Filled Cover and secure in position with the buckle and strap.
IMPORTANT: Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
5. Ensure that the spa base is plugged into a properly located and sized electrical outlet and press the
button to turn on the control panel. Press the
"Spa Control Panel" operation section.
S AVE THESE INSTRUCTIONS
SET UP (continued)
button to defl ate the tub (see drawing 12).
button again to
button on the control panel to activate the heater, see
(353PO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 02/03/2023
"
353
English
PO
11
12
13
Page 11