Intex PureSpa SB-HSWF10 Owner's Manual page 18

OPERATION (continued)
Temp set
HST
o
at ( C/F)
40/104 000H
40/104 000H
40/104 012H
40/104 012H
Freeze Protection: the spa heater is programed to automatically heat the water if the water
temperature falls below 39°F (4°C). While the spa should be stored during the winter months,
the system will protect the internal components in the event of occasional freezing temperatures.
The spa must be plugged in and the GFCI/RCD reset. The system will engage the fi lter pump
along with the heater and will operate both until the water reaches 50°F (10°C).
If extended freezing weather is expected, please disassemble the spa and store it during winter
according to the storage instructions.
Once the self-heating program is triggered, it cannot be switched off on the control panel until
the water temperature has reached at least 41°F (5°C), unless it is unplugged.
S AVE THESE INSTRUCTIONS
(353PO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 02/03/2023
Heater Function Setting Examples
HDT
HST & HDT functions are off . Heating system has to
be activated manually by pressing (
000H "Spa Control Panel" section for details. The heater will
continuously heat until the temperature is reached and
then hold at that temperature.
Turn the heater on and set a run time at which point the
heater will turn itself off . The heater will continuously
heat until the temperature is reached and then hold at
005H
that temperature until the 5 hours run time has expired,
regardless if the water temperature has reached
104°F/40°C or not.
Turn the heater on some time into the future to a set
temperature and set a run time at which point the heater
will turn itself off . The heater will start after 12 hours and
005H continuously heat until the temperature is reached and
then hold at that temperature until the 5 hours run time
has expired, regardless if the water temperature has
reached 104°F/40°C or not.
Turn the heater on some time (in hours) into the future
to a set temperature. The heating system will start after
12 hours, and continuously heat until the water reaches
104°F/40°C and then hold at that temperature. When the
spa water temperature drops 1.8-3.6°F (1-2°C) below the
000H
set temperature the heating system will restart. When the
fl ame icon on the display is red, the heating system is
activated. When the fl ame icon turns green, the water is
at the set temperature. The heating system is at rest and
the fi ltration system will continue working nonstop.
English
Action
) button. See
Page 18
353
PO