Table of Contents
Advertisement
248476r4.book Seite 34 Freitag, 28. Oktober 2011 3:10 15
Factory default settings and parameter ranges
Parameter
Pathology
Program
Mode
CPAP
IPAP
EPAP or
PEEP
PS
Ti
Backup Rate
34
Mode
Default
Normal
Prog 1
ST
8.0 cm H
10.0 cm H
4.0 cm H
6.0 cm H
2.0 sec
10 bpm
Description
Disease-specific preset setting values to facilitate
efficient commencement of therapy (see
page 10).
Note: If the default pathology settings have been
changed, the button is marked with an asterisk.
Options: Obstructive, restrictive, normal, obesity
hypoventilation
The program setting is only available if the option
Multi program in the Configuration menu is set to
Dual. Clinical settings and alarms can be stored in
two different programs (see page 26).
Note: The program name can be set via ResScan.
Options: Prog 1, Prog 2
Sets the therapy mode (see page 2).
Options: CPAP , S, ST (PS), T, iVAPS, PAC
O
Continuous Positive Airway Pressure
2
Sets the fixed treatment pressure (in CPAP mode).
Note: When changing from CPAP to bilevel
mode, the set CPAP pressure becomes the new
IPAP and EPAP pressure.
Options: 4–20 cm H
O; 0.2 cm H
2
O
Inspiratory Positive Airway Pressure
2
IPAP is the pressure which will be delivered to
the patient when the device is triggered into
inspiration.
Options: 2–40 cm H
O; 0.2 cm H
2
O
Expiratory Positive Airway Pressure
2
EPAP is the pressure which will be delivered to
the patient when the device is cycled into
expiration (see page 56).
Options: 2–25 cm H
O (always below or equal to
2
IPAP);
0.2 cm H
O increments
2
O
Pressure support; PS = IPAP-EPAP
2
The pressure support is the pressure increase
(above EPAP/PEEP) delivered during inspiratory
phase.
Options: 0–38 cm H
O; 0.2 cm H
2
Sets the inspiratory time.
Options: 0.2–4 sec or 2/3 of one breath cycle
defined by Respiratory or Backup Rate;
0.1 sec increments
Sets the breaths per minute (bpm).
Options: 5–60 bpm, 1 bpm increments
O increments
2
O increments
2
O increments
2
Advertisement
Table of Contents
Troubleshooting
