Troubleshooting - Haier HDW15U2I1 User Manual

NZ AU
Problem Possible cause
No power.
The door is not properly
closed.
Dishwasher
will not start
Water tap not turned on.
Blocked strainer in water
inlet hose.
Lower spray
Spray arm holes are
arm rotates
blocked by small items or
with difficulty
food particles.
Detergent compartment
Cover of
has been overfilled.
detergent
dispenser
Detergent dispenser is
cannot be
clogged with remnants
closed
of detergent.
Compartment was damp
when filled with detergent.
Remnants
of detergent
stuck inside
Utensils are blocking
dispenser
the detergent dispenser
from opening.
Blocked drain connection.
Water
remains
Drain hose is crimped,
inside
bent，or blocked.
dishwasher
after wash
Pump is jammed.
has ended
Filter(s) blocked.
Display This is normal. The display
flashing while remains on although the
Keylock is on buttons are disabled.
has not been pressed.

Troubleshooting

What to do
Ensure the dishwasher is plugged in and
the power supply is turned on at the wall.
Close the door.
Press .
Ensure water is connected and turned on.
Check the strainer and clean if necessary
– it is located where the water inlet hose
screws into the tap.
Clean the spray arm. Refer to 'Maintenance'
for instructions.
Remove detergent until the cover can be
closed.
Wipe dispenser out with a damp cloth.
Dry the dispenser before adding detergent.
Wipe dispenser out with a damp cloth.
Dry the dispenser before adding detergent.
Ensure there are no large utensils
positioned in a way that will stop the
dispenser cover from opening when the
dishwasher door is closed.
Check that drain connection is free from
blockages.
Check the drain hose and straighten if
needed.
Call your Haier Authorised Service Centre
or Customer Care.
Clean the filter(s). See 'Maintenance' for
instructions.
No action required.
28