Table of Contents
Advertisement
WHAT IS A REGULATOR?
Your WEBER gas grill is
equipped with a pressure
regulator, which is a device
to control and maintain
uniform gas pressure as gas
is released from the LPG
cylinder.
CONNECTING THE REGULATOR
TO THE LPG CYLINDER
A) Connect regulator to LPG cylinder.
m WARNING: Make sure that the LPG
cylinder or regulator valve is closed.
Some regulators push ON to connect and pull OFF
to disconnect; others have a nut with a left-hand
thread that connects to the cylinder valve. Identify
your regulator type and follow one of the connection
instructions specific to that regulator.
Connect by Turning Clockwise
Screw regulator onto cylinder by turning fitting
clockwise (1). Position the regulator so that the vent
hole (2) faces down.
Connect by Turning Anti-Clockwise
Screw regulator onto cylinder by turning fitting anti-
clockwise (3) (4).
Connect by Turning Lever/Snapping into Position
Turn regulator lever (5) clockwise to the off position.
Push regulator down on cylinder valve until regulator
snaps into position (6).
Connect by Sliding Collar
Make sure regulator lever is in the off position
(7) (10). Slide the collar of the regulator up (8) (11).
Push the regulator down onto the cylinder valve and
maintain pressure. Slide collar down to close (9) (12).
If regulator does not lock, repeat procedure.
Note: The regulator illustrations shown in this manual may
not be similar to the regulator you are using for your grill,
due to different country or regional regulations.
CONNECTING THE REGULATOR
1
2
3
4
5
6
7
8
10
11
9
12
9
WWW.WEBER.COM
Advertisement
Table of Contents
