Connecting The Regulator; What Is A Regulator; Connecting The Regulator To The Cylinder - Weber Spirit E210 ORIGINAL Owner's Manual

WHAT IS A REGULATOR?

Your Weber gas grill is
®
equipped with a pressure
regulator, which is a device
to control and maintain
uniform gas pressure as gas
is released from the LPG
cylinder.

CONNECTING THE REGULATOR

TO THE CYLINDER
A) Connect regulator to LPG cylinder.
m WARNING: Make sure that the LPG
cylinder or regulator valve is closed.
Some regulators push ON to connect and pull OFF
to disconnect; others have a nut with a left-hand
thread that connects to the cylinder valve. Identify
your regulator type and follow one of the connection
instructions specific to that regulator.
Connect by Turning Clockwise
Screw regulator onto cylinder by turning fitting
clockwise (1). Position the regulator so that the vent
hole (2) faces down.
Connect by Turning Anti-Clockwise
Screw regulator onto cylinder by turning fitting anti-
clockwise (3) (4).
Connect by Turning Lever/Snapping into Position
Turn regulator lever (5) to the down/off position. Push
regulator down on cylinder valve until regulator snaps
into position (6).
Connect by Sliding Collar
Make sure regulator lever is in the off position (7) (10).
Slide the collar of the regulator up (8) (11). Push the
regulator down onto the cylinder valve and maintain
pressure. Slide collar down to close (9) (12). If
regulator does not lock, repeat procedure.
CONNECTING THE REGULATOR
1
2
3
4
6
7
5
8
10
11
9
12
15
WWW.WEBER.COM
®