Connecting The Regulator To The Cylinder; What Is A Regulator; Connecting The Hose To The Valve - Weber Q Series Owner's Manual

WHAT IS A REGULATOR?

A pressure regulator is a
device to control and maintain
uniform gas pressure as gas is
released from the LPG cylinder.
m DANGER
Do not store an extra (spare) or disconnected
gas supply cylinder under or near this grill.

CONNECTING THE HOSE TO THE VALVE

A hose and regulator should be supplied by your retailer
and must be connected to your grill. Follow the instructions
provided in your hose kit.
CONNECTING THE REGULATOR
TO THE CYLINDER
Only use cylinders with a minimum capacity of 2,5 kg and a
maximum capacity of 13 kg.
For Customer's in Japan use cylinders with a capacity of
2-8 kg.
A) Connect regulator to cylinder.
m WARNING: Make sure that the cylinder or
regulator valve is closed.
Some regulators push ON to connect and pull OFF
to disconnect; others have a nut with a left-hand
thread that connects to the cylinder valve. Identify
your regulator type and follow one of the connection
instructions specific to that regulator.
Connect by Turning Clockwise
Screw regulator onto cylinder by turning fitting
clockwise (1). Position the regulator so that the vent
hole (2) faces down.
Connect by Turning Anti-Clockwise
Screw regulator onto cylinder by turning fitting anti-
clockwise (3) (4).
Connect by Turning Lever/Snapping into Position
Turn regulator lever (5) clockwise to the off position.
Push regulator down on cylinder valve until regulator
snaps into position (6).
Connect by Sliding Collar
Make sure regulator lever is in the off position (7) (10).
Slide the collar of the regulator up (8) (11). Push the
regulator down onto the cylinder valve and maintain
pressure. Slide collar down to close (9) (12). If regulator
does not lock, repeat procedure.
Note: The regulator illustrations shown in this manual may
not be similar to the regulator you are using for your grill, due
to different country or regional regulations.

CONNECTING THE REGULATOR TO THE CYLINDER

5
m IMPORTANT NOTICE: We recommend that you replace the gas hose assembly on your
gas grill every five years. Some countries may have requirements that the gas hose be
replaced within less than five years, in which case that country's requirement would
take precedence.
For replacement hose, regulator, and valve assemblies, contact the Customer Service
Representative in your area using the contact information on our web site. Log on to
www.weber.com.
1
2
3
4
6
7
8
10
11
REPLACEMENT HOSE, REGULATOR AND VALVE ASSEMBLY
9
12
11
WWW.WEBER.COM