Table of Contents
Advertisement
BURNER TUBE CLEANING
OR REPLACEMENT (continued)
Remove Burner Tubes
A) Slide burner tube 1 out from under the guide screw
and washer. Move burner tube 1 slightly to the left to
detach it from Crossover tube (1).
B) Remove Crossover tube (2).
C) Lift burner tube 1 up and out of cookbox while guiding
the wires through the hole in the cookbox (3).
D) Slide burner tube 2 out from under the guide screw
and washer. Lift burner tube 2 up and out of the
cookbox (4).
Clean Burner Tubes
You will need: A torch, a wire (a straightened-out coat
hanger), a suitable stainless steel bristle brush, and a soft
bristle brush (toothbrush).
A) Look inside each burner tube and Crossover tube with
a torch (5).
B) Clean any debris or blockage from the inside of the
tubes with the wire (6).
C) Check spider/insect screens at the ends of the burner
tubes and clean them using the soft bristle brush (7).
m CAUTION: Do not clean the spider/insect
screens with hard or sharp tools. Do not
dislodge the spider/insect screens or
enlarge the screen openings.
D) Use the steel bristle brush to clean the outside of the
burner tubes and the Crossover tube. This is done to
make sure all burner ports (openings) running along
the length of the tubes are fully open. When cleaning
burner tube 1, avoid damaging the igniter electrode by
carefully brushing around it (8).
m CAUTION: Do not enlarge the burner
ports when cleaning.
20
WWW.WEBER.COM
ANNUAL MAINTENANCE
1
2
3
4
5
6
7
8
Advertisement
Table of Contents
