Toro 03606A Operator's Manual page 22

InfoCenter Icon Description
SERVICE DUE Indicates when scheduled service
should be performed
Engine rpm/status—indicates the
engine speed (rpm)
Hour meter
Info icon
Fast
Slow
Fuel level
Stationary regeneration required
Glow plugs are active
Raise cutting units
Lower cutting units
Operator must sit in seat
Parking-Brake Indicator—indicates
when the parking brake is On
Identifies the range as High
(Transport)
Neutral
Identifies the range as Low (Mow)
Coolant Temperature—indicates the
engine-coolant temperature in either
°C or °F
Temperature (hot)
PTO is engaged
Denied or not allowed
Engine start
Stop or shutdown
InfoCenter Icon Description (cont'd.)
Symbols are often
combined to form
sentences. Some
examples are shown
below
22
Engine
Key switch
Indicates when the cutting units are
being lowered
Indicates when the cutting units are
being raised
PIN code
CAN bus
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
Switch
Operator must release switch
Operator should change to indicated
state
Operator should put machine in
neutral
Engine start denied
Engine shutdown
Engine coolant too hot
DPF ash-accumulation
notification—Refer to Servicing
the Diesel-Oxidation Catalyst (DOC)
and the Soot Filter (page 51)
details.
Sit down or set parking brake
for