Toro 03606A Operator's Manual page 24

Machine-Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 8 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
auto idle time delay, Blade Count, Mow Speed, Height
of Cut (HOC), F Reel RPM and R Reel RPM. These
settings can be locked by using the Protected Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the
code, contact your Authorized Toro Distributor for
assistance.
1. From the M M
AIN
scroll down to the S
right button (Figure
Figure 26
2. In the S M
ETTINGS
scroll down to the P
the right button (Figure
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
, use the center button to
ENU
M and press the
ETTINGS ENU
26).
, use the center button to
ENU
M and press
ROTECTED ENU
27A).
3. To enter the PIN code, press the center button
until the correct first digit appears, then press
the right button to move on to the next digit
(Figure 27B and
until the last digit is entered and press the right
button once more.
4. Press the middle button to enter the PIN code
(Figure 27D).
Wait until the red indicator light of the InfoCenter
illuminates.
Note:
If the InfoCenter accepts the PIN code
and the protected menu is unlocked, the word
"PIN" displays in the upper right corner of the
screen.
g028523
Note:
Rotate the key switch to the O
then to the O
N
You have the ability to view and change the settings in
the Protected Menu. Once you access the Protected
Menu, scroll down to Protect Settings option. Use the
right button to change the setting. Setting the Protect
Settings to O
FF
settings in the Protected Menu without entering the
PIN code. Setting the Protect Settings to O
protected options and requires you to enter the PIN
code to change the setting in the Protected Menu.
After you set the PIN code, rotate the key switch O
and back to the O
feature.
24
Figure 27
Figure 27C). Repeat this step
position locks the protected menu.
allows you to view and change the
position to enable and save this
N
g028522
position and
FF
hides the
N
FF