Mounting The Device - SGM IDEA BEAM 300 Manual

GB

Mounting the device

Pleas consider the EN 60598-2-17 and the other respective national norms
during the installation. The installation must only be carried out by a
qualified person.
The applicable temperature for the lignting is between-25°C～45°C Do not use the lighting under or above
the temperature.
The installation of the effect has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate safety
cable.
Never stand directly below the device when mounting, removing or servicing the fixture.
The operator has to make sure the safety relating and machine technical installations are approved by an
expert before taking the device into operation for the first time.
These installations have to be approved by a skilled person once a year.
Before taking into operation for the first time, the installation has to be
approved by an expert.
Cautions:
The effect should be installed outside areas where persons may reach it, walk by or be seated.
When installing the device, make sure there in no highly inflammable
material within a distance of min. 0,5m
Overhead mounting requires extensive experience, including amongst others calculating working load limits,
installation material being used, and periodic safety inspection of all installation material and the device. If
you lack these qualifications, do not attempt the installation yourself. Improper installation can result in
bodily injury.
The electric connection must only be carried out by a qualified electrician.
Before mounting make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
Connect the fixture to the mains with the power plug.
Idea Beam 300
CAUTION
CAUTION
CAUTION
CAUTION
７
SGM
XM350 V1.0 NR