Replacing The Filter; Technical Data; Explanation Of Lights - DeLonghi Autentica ETAM29.51 Series Instructions For Use Manual

9. Deliver hot water by turning the hot water/steam dial
(B1) to the I position.
12. Deliver at least 500 ml of hot water, then turn the hot water/
steam dial to the O position.
The filter is now active and you can use the coffee machine.

Replacing the filter

After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter:
1. Extract the tank (A15) and exhausted filter (C3);
2. Take the new filter out of its packet and proceed as illus-
trated in points 2 to 10 in the previous section.
The new filter is now active and you can use the coffee machine.

EXPLANATION OF LIGHTS

LIGHTS DISPLAYED
FLASHING
FLASHING
ON
ON + FLASHING
FLASHING + ON
FLASHING

TECHNICAL DATA

Voltage:
Absorbed power:
Pressure:
Max. water tank capacity:
Size: LxDxH:
Cord length:
Weight:
Max. beans container capacity:
•
•
•
•
POSSIBLE CAUSE
Insufficient water in the tank (A18).
The grounds container (A14) is full.
After cleaning, the grounds container has not
been replaced.
The coffee beans have run out.
The pre-ground coffee funnel is clogged.
The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel.
The machine must be descaled.
17
220-240 V~ 50/60 Hz max. 10A
195x480x340 mm
The appliance complies with the following EC
directives:
Low Voltage Directive 2006/95/EC and subsequent
amendments;
EMC Directive 2004/108/EC and subsequent amendments;
European Standby Regulation 1275/2008
Materials and accessories coming into contact with food
conform to EEC regulation 1935/2004.
SOLUTION
Fill the tank (A18) with water and/or insert it
correctly, pushing it as far as it will go until it
clicks into place.
Empty the grounds container and drip tray
(A13), clean and replace (fig. 18). Important:
when removing the drip tray, the grounds con-
tainer MUST be emptied, even if it contains few
grounds. If this is not done, when you make the
next coffees, the grounds container may fill up
more than expected and clog the machine.
Remove the drip tray (A13) and insert the
grounds container.
Fill the beans container (fig. 9).
Empty the funnel with the help of a brush as
described in the section "Cleaning the pre-
ground coffee funnel" (page 15).
Place pre-ground coffee in the funnel or dese-
lect the "pre-ground" function (fig. 13).
The descaling procedure described in the section
"Descaling" needs to be performed as soon as
possible (page 16).
1450W
1,5MPa (15 bar)
1,4 l
1050 mm
9,1 kg
200 g