Turning The Appliance On; Turning The Appliance Off; Setting Water Hardness; Setting Temperature - DeLonghi Autentica ETAM29.51 Series Instructions For Use Manual

2. Place a container with a minimum capacity of 100 ml under
the cappuccino maker (fig. 3).
3. Plug the appliance into the mains socket and press the
main switch on the side of the appliance (fig. 4).
4. Press the button (A5) (fig. 5).
5. The light flashes on the touch screen (fig. 6).
6. Turn the steam dial to the "I" position (fig. 7). Water is de-
livered from the cappuccino maker.
7. When delivery stops automatically, turn the steam dial
back to the "O" position.
The appliance goes off.
To reuse it, press the button (A5) again.
Please note :
• The first time you use the appliance, you need to make 4-5
cups of coffee before the appliance starts to give satisfac-
tory results.

TURNING THE APPLIANCE ON

Please note!
• Before turning the appliance on, make sure the main
switch is pressed (fig. 4).
• Each time the appliance is turned on, it performs an auto-
matic preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this
cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath. Avoid contact with
splashes of water.
• To turn the appliance on, press the
The light (B3) flashes while the appliance is heating
up and performing an automatic rinse cycle. By circulating
hot water, the appliance heats both the boiler and the in-
ternal circuits.
The appliance is at temperature when the
the coffee lights come on.

TURNING THE APPLIANCE OFF

Whenever the coffee machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts.
Avoid contact with splashes of water.
• To turn the appliance off, press the
• The light (B3) flashes to indicate the appliance is going
off.
Please note!
If you will not be using the appliance for some time, unplug
from the mains socket:
• first turn the appliance off by pressing the
(fig. 5);
• press the main switch on the side of the appliance (fig. 4).
Important!
Never press the main switch while the appliance is on.

SETTING WATER HARDNESS

For instructions on setting water hardness, see page 16.

SETTING TEMPERATURE

If you want to modify the temperature of the water used to
make the coffee (low, medium, high, maximum), proceed as
follows:
1. With the appliance off (standby), but the main switch
pressed (fig. 4);
2. press and hold the
icons on the touch screen (B) come on;
3. press the
temperature:
4. Press the
exit without making the modification). The lights/icons go
button (fig. 5).
off.
The temperature is now programmed.

AUTO-OFF

The time can be changed so that the appliance switches off after
being idle for 15 or 30 minutes, or after 1, 2 or 3 hours.
light goes off and
To reprogramme auto-off, proceed as follows:
1. With the appliance off (standby), but the main switch
pressed (fig. 4);
2. press and hold the
icons on the touch screen (B) come on;
3. press the
button (fig. 5).
10
icon (B2) until the lights and
icon (B13) to select the required
low
medium
high
maximum
icon (B12) to confirm (or (B10) to
icon (B8) until the lights and
icon (B13) to select the required time:
15 min.
30 min.
1 hour
button