Appendix; Care; Contact With Liquid; Questions And Answers - Siemens Gigaset C285-2 User Manual

Appendix

Care

Wipe the base station and handset with a
damp cloth (do not use solvents) or an anti-
static cloth.
Never use a dry cloth. This can cause static.

Contact with liquid

If the handset has come into contact with
liquid:
1. Immediately switch the handset off and
remove the batteries.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset,
with the battery compartment open and
the keypad facing down, in a dry, warm
place for at least 72 hours (not in a micro-
wave oven, convection oven, or similar
place).
4. Do not switch on the handset again un-
til it has completely dried.
When it has fully dried, you should be able to
use it again normally.

Questions and answers

If you have any questions about the use of
your telephone, you can contact us at any
time at www.gigaset.com/customercare.
The table below (page 33) contains a list of
common problems and possible solutions.
Troubleshooting
The display is blank.
1. The handset is not switched on.
2. The batteries are empty.
The handset does not respond to a key press.
¥
The keypad lock is activated.
!
Base Search and
screen.
1. The handset is outside the range of the base
2. The handset has been de-registered. Please
3. The base station is not switched on.
Handset does not ring.
¥
The ring tone is switched off.
You cannot hear the ring tone/dialing tone.
¥ Base station's phone cord has been replaced.
¥
3
2
1
The other party cannot hear you.
j
You have pressed the display key
¥
¥
a
Press and hold the End Call key.
¥
Charge or replace the batteries (page 9).
Press and hold the pound key
Ä
is flashing on the display
¥
station.
Reduce the distance between handset/
base station.
¥
Register is flashing on the display screen.
Register the handset (page 26).
¥
Check the base station power cord
(page 9).
Activate the ring tone (page 30).
When purchasing a new cord, make sure that
it has the correct pin connections.
Correct phone jack assignment
4
5
6
key. The handset is on hold.
Press the left display key to switch on the
microphone again.
Appendix
#
(page 1).
1 unused
2 unused
3 a
4 b
5 unused
6 unused
§Mute§
or the
33