Parkside Performance 322701 1901 Operation And Safety Notes page 36

2 gear:
nd
Suitable for:
Speed:
Torque:
˜ Setting the rotating direction
m
ATTENTION! RISK OF PRODUCT
DAMAGE!
Do not operate the rotation direction
switch 5 until the product has come to
a standstill.
Change the direction of rotation by pressing
¾
the rotation direction switch 5 towards the
left or right (fig. G).
When the rotation direction switch 5 is in
¾
the middle position, the on/off switch 6 is
locked.
˜ Torque control
This product is equipped with a torque control that
disengages the spindle when a predefined torque
is exceeded.
The torque can be adjusted by turning the
¾
torque sleeve 3 (fig. H).
Small screws or soft materials: Select a low
¾
level.
Large screws, hard materials or removing
¾
screws: Select a high level.
For drilling operation: Turn the torque sleeve
¾
3 to the position.
˜ Switching on and off
NOTE
The on/off switch 6 cannot be locked.
Drilling
High
Low
Switching on: Press and hold the on/off
¾
switch 6 .
Regulate the speed as required (see "Speed
control") (fig. I).
Switching off: Release the on/off switch
¾
6 .
˜ Speed control
By using the on/off switch 6 , you can
¾
progressively control the speed:
Pressure
Gentle pressure:
Greater pressure:
˜ LED work light
This product is equipped with a LED work light
11 to illuminate the immediate working area to
improve visibility in poorly lit areas.
The LED work light 11 lights up automatically
¾
as soon as the product is switched on.
NOTE
The LED work light 11 stays on for an
u
additional approx. 10 seconds after
switching off the product.
˜ Trial run
NOTE
Always carry out a no-load trial run before
u
starting work and after every accessory
tool replacement. Switch the product off
immediately if the accessory tool is not
running smoothly, if considerable vibration
occurs or if you hear abnormal noises.
Speed
Lower speed
Higher speed
GB/IE 35