Parkside Performance 322701 1901 Operation And Safety Notes page 35

˜ Attaching/removing the
accessory tool
m
CAUTION! RISK OF INJURY!
Accessory tools can be sharp and
may become hot during use. Always
wear protective gloves when handling
accessory tools!
m
WARNING!
Always switch the product off, remove
the battery pack 10 and let the
product cool down before making any
adjustments!
m
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
tool when the product is in operation.
m
CAUTION! RISK OF INJURY!
After the product has been switched off,
u
the accessory tool continues moving for
some time. Do not touch the accessory tool
and do not attempt to brake it.
This product is equipped with an automatic
spindle lock to open or close the chuck 1 with
the chuck sleeve 2 .
Open the chuck 1 : Turn the chuck sleeve
¾
2 in a counter-clockwise direction (Fig. E).
Insert a suitable accessory tool into the chuck
¾
1 as deep as required.
Close the chuck 1 : Hold the accessory tool
¾
in position. Turn the chuck sleeve 2 in a
clockwise direction.
34 GB/IE
NOTES
This product is equipped with a Röhm drill
u
chuck with an anti-lock function.
If you attempt to open the fully opened
u
chuck 1 further, the anti-lock function will
be activated to protect the chuck.
When the anti-lock function is activated,
u
the chuck 1 cannot be closed by turning
the chuck sleeve 2 in a clockwise
direction. A ratcheting sound will be
produced when you attempt to close the
chuck.
Deactivating the chuck's 1 anti-lock
u
function: Turn the chuck sleeve 2 in a
clockwise direction by a certain extent.
Then, turn the chuck sleeve suddenly and
quickly in a counter-clockwise direction.
Repeat this action if the anti-lock function
is still active. When the anti-lock function is
deactivated, you should be able to close
the chuck 1 without ratcheting sounds.
˜ Gear selection
m
ATTENTION! RISK OF PRODUCT
DAMAGE!
Do not operate the gear selector
4 until the product has come to a
standstill.
Change the gear by sliding the gear selector
¾
4 forwards or backwards (fig. F).
1 gear:
st
Suitable for:
Speed:
Torque:
Screwing
Low
High