Cleaning; Maintenance; Storage; Transportation - Parkside Performance 322701 1901 Operation And Safety Notes

˜ Cleaning
Never allow fluids to get into the product.
¾
The product must always be kept clean, dry
¾
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
¾
safe use and prolong the life of the product.
Clean the product with a dry cloth. Use a
¾
soft brush for areas that are hard to reach.
In particular clean the air vents after every
¾
use with a cloth and soft brush.
The vents must always be clear.
¾
NOTE
Do not use chemical, alkaline, abrasive
u
or other aggressive detergents or
disinfectants to clean this product as they
might be harmful to its surfaces.
˜ Maintenance
The product is maintenance-free.
¾
Before and after each use, check the product
¾
and accessories (e.g. accessory tools) for
wear and damage. If required, exchange
them for new ones as described in this
instruction manual. Observe the technical
requirements (see "Technical data").
˜ Repair
This product does not contain any parts that can
be repaired by the user. Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired.
˜ Storage
Push the rotation control switch 5 to the
¾
centre position to lock the on/off switch 6 .
Clean the product as described above.
¾
Store the product and its accessories in a
¾
dark, dry, frost-free, well-ventilated place.
Always store the product in a place that is
¾
inaccessible to children. The ideal long term
storage (longer than 3 months) temperature
is between +20 and +26 °C.
Guide the drill bit into the bit holder 8 .
¾
Store the product in its carrying case 19.
¾
Battery pack advice
Only store the battery pack 10 partially
¾
charged. The battery pack should be
charged to 40 to 60 % (red and orange LED
in the charge indicator 14 light up) before
storing for extended periods.
Check the battery pack 10 charge about
¾
every 3 months when storing for extended
periods. Recharge as necessary.
˜ Transportation
Push the rotation control switch 5 to the
¾
centre position to lock the on/off switch 6 .
Transport the product in its carrying case 19.
¾
Protect the product from any heavy impact
¾
or strong vibrations which may occur during
transportation in vehicles.
Secure the product to prevent it from slipping
¾
or falling over.
GB/IE 37