3. Remove both plastic caps sideways.
3
Special spanner A and sealing caps B
(2 off) and C (1 off) are supplied with the
appliance.
4. Remove screw D with its compression
spring using special spanner A.
5. Turn sealing cap C upside down as
shown in the illustration.
6. Seal hole using sealing cap C.
7. Unscrew and remove two screws E us-
ing special spanner A.
8. Unscrew and remove four screws F us-
ing special spanner A.
9. Remove transit bar G.
10.Screw in the four screws F again.
11.Seal the two big holes using sealing
caps B.
Important! Press all sealing caps B (2 off)
and C (1 off) in firmly, so that they snap
into place. (Splash protection).
Where to install
Important! The appliance must not be used in a room where there is a dan-
ger of frost. Frost damage or impaired operation! Frost damage is not cov-
ered by the warranty.
• The surface on which the appliance is to be installed must be firm and lev-
el. Do not install the appliance on carpets or on soft floor coverings.
• The surface on which the appliance is to be installed must be clean and
dry and free from coverings that move, so that the appliance does not
slide.
35