Install Cycle (Wavetouch™); Install Cycle (Iq Touch™) - Electrolux EWFLW65H Technical & Service Manual

Electronic Control
Install Cycle (WaveTouch™)
1. The machine will first wake up on setting up the unit
to display language selection. Press NEXT to display
the Install cycle. The Install cycle can be run at
this time. If not, the Install cycle can be accessed
through the PREF menu in the option window. Press
the select key once you scroll to the PREF selection.
Then scroll through this menu until you get to the
Install cycle. Press the select key then follow the
instructions (remove all articles from the washer
drum). You can also get to this cycle by performing
a full reset of factory settings.
2. At cycle completion, the LCD window may display
"INSTALL PASS!", meaning the washer is properly
installed and ready for use. If it prompts an action
such as "NO WATER", "CHECK HOSES" or "CALL
SERVICE 877-435-3287", review the installation
steps and make the necessary corrections before
attempting to use the washer.
3. The washer will exit the Installation Cycle and return
to normal operation the next time the washer is
used.
Install Cycle (IQ Touch™)
1. Wake the washer up by pressing any button (except
the cancel button).
2. Rotate the cycle knob to the "Hand Wash" cycle.
3. Press the Start/Pause button, then the CANCEL
button.
4. Wake the unit up again, immediately and
simultaneously press and hold the MY FAVORITE
and ECO FRIENDLY buttons for 5 seconds. The
display will show "INSTAL CYCLE" with the
estimated time of cycle completion.
5. Press the START/PAUSE button to begin the cycle.
Installation cycle will test for electronic issues, wiring
issues & water flow issues. At cycle completion,
the display will show INSTAL PASS!" or prompt an
action during the cycle such as "CALL SERVICE",
"NO WATER" or "CHECK HOSES". Correct the
action and repeat the cycle for proper installation.
Washer will exit the Install Cycle and return to
normal operation the next time the knob is turned.
The INSTALL CYCLE is prompted automatically
only once when the washer is turned on the first
time at the end of installation. After that, if you
wish to run a subsequent INSTALL CYCLE when
moving the washer or modifying your installation,
you may perform your own INSTALL CYCLE
by selecting it in the set prefs feature and then
following the screen prompts.
Washer will stay awake for 3 minutes after the
Installation Cycle. If you wish to immediately run
the washer through a washing cycle, press the
cancel button to put the unit to sleep and then
rewake it immediately, to continue the normal
operating mode.
The errors may result from the following
conditions:
• NO WATER error — Water inlet hoses have not
been attached to water supply or water supply valves
have not been turned on. Install hoses correctly and
turn on water supply valves.
• CHECK HOSES error — The hot inlet hose may
have been connected to the cold water supply and
the cold inlet hose may have been connected to
the hot water supply. Check hoses for correction
supply connection. If incorrect, disconnect hoses
and connect to correct inlets according to Installation
Instructions.
• CALL SERVICE —Troubleshoot and repair as
needed. Repeat the INSTALL CYCLE when
corrections are completed.
3-18