Table of Contents
Advertisement
What to do if...
Remedying small malfunctions yourself
If while the appliance is operating a short acoustic signal sounds 3 times
and one of the following messages appears in the display:
– „No incoming water/Check tap & Hose",
– „No drain - check/drain hose/filter" or "Pump Blocked",
– "Door not Closed",
please have a look at the following table.
When the fault is remedied, press the START/PAUSE key.
If "Warning : E and number or letter" is displayed: Switch the appliance off
and on again. Re-set the program. Press the START/PAUSE key.
If the warning is displayed again, please contact the Customer Care
Department and inform them of the warning.
Problem
Washing machine does not
work.
Door cannot be closed.
Display shows: "Selection er-
ror".
Display shows: "Door not
Closed/Please check"
Display shows: "No incoming
water/Check tap & Hose"
26
Possible cause
Mains plug not plugged in
or fuse not working.
Door not closed properly.
START/PAUSE key was
not pressed for long
enough.
Child safety device en-
gaged.
The selected function can-
not be combined with oth-
er program settings.
Door not closed properly.
Tap turned off.
Filter in the screw connec-
tion of the inlet hose is
blocked.
Water tap is blocked with
limescale or faulty.
Remedy
Plug in mains plug. Check fuse.
Close door - there should be an
audible click.
Press START/PAUSEkey for
longer.
Release child safety device.
Make another selection.
Close door - there should be an
audible click.
Start program again.
Turn the tap on.
Turn off the water tap. Unscrew
hose, take out filter and clean it.
Check the water tap and have it
repaired if necessary.
Advertisement
Table of Contents
