Table of Contents
Advertisement
• If the location in which the appliance is to be installed is fitted with small-
format tiles, put a rubber mat (available in the shops) under the appliance.
If the appliance is to stand on a plinth:
In order for the appliance to be secure on
the plinth, fixing plates*) must be mount-
ed, into which the appliance is inserted.
If the appliance is to stand on floors that vibrate, e. g. floors of wooden
joists with deal boards:
If possible, install the appliance in one corner of the room.
1. Screw a water-resistant wooden board (at least 15 mm thick) onto at least
2 of the floor joists.
2. Affix fixing plates *) onto the wooden board, into which the appliance is in-
serted.
*) The fixing plates can be obtained from the Customer Care Department.
Making the appliance level
3
Automatic foot: The rear foot on the left-hand side of your washing ma-
chine is built as a shock absorbing foot, which is why the appliance gives in
the back left-hand corner if put under load. The automatic foot guarantees
that the appliance does not move even at high spin speeds. Basically the
automatic foot does not need to be set.
The four feet of the appliance are pre-ad-
justed.
Large degrees of unevenness can be
compensated for by individually adjust-
ing the height adjustable screw feet.
Use the special spanner supplied to do
this.
Important! Do not use pieces of wood,
cardboard or such like to level out une-
venness in the floor, but adjust the height
adjustable screw feet instead.
36
Advertisement
Table of Contents
