Where To Install - Electrolux Lavamat 60800 User Information

3
Special spanner A and sealing caps B
(2 off) and C (1 off) are supplied
with the appliance.
3. Remove screw D with its compres-
sion spring using special spanner A.
4. Seal hole using sealing cap C.
5. Unscrew and remove two screws E
using special spanner A.
6. Unscrew and remove four screws F
using special spanner A.
7. Remove transit bar G.
8. Screw in the four screws F again.
9. Seal the two big holes using sealing
caps B.
Important! Press all sealing caps B
(2 off) and C (1 off ) in firmly, so
that they snap into place. (Splash
protection).

Where to install

Important! The appliance must not be used in a room where there is a
danger of frost. Frost damage or impaired operation! Frost damage is
not covered by the warranty.
• The surface on which the appliance is to be installed must be firm
and level. Do not install the appliance on carpets or on soft floor cov-
erings.
• The surface on which the appliance is to be installed must be clean
and dry and free from coverings that move, so that the appliance
does not slide.
• If the location in which the appliance is to be installed is fitted with
small-format tiles, put a rubber mat (available in the shops) under
the appliance.
26