Table of Contents
Advertisement
Electrical connection
Details about the voltage, type of supply and the fuses required are to be
found on the rating plate. The rating plate is next to the doorway.
Connecting to the water supply
Important!
• This appliance must not be connected to the hot water system.
• When connecting it, use only new hose kits.
• Only connect the appliance to the drinking water supply. Rain water or
water for industrial use may only be used if it fulfils the requirements of
DIN1986 and DIN1988.
• Do not kink or crush the water inlet hose or drain hose.
Permitted water pressure
The water pressure must be at least 1bar (=10N/cm
a maximum of 10bar (=100N/cm
– If more than 10bar: Connect a pressure reduction valve.
– If less than 1bar: Disconnect the appliance end of the inlet hose from the
solenoid inlet valve and remove the flow meter. (In addition remove the fil-
ter using pointed pliers and take out the rubber gasket behind it.) Re-in-
sert the filter.
2
=1MPa).
2
=0.1MPa) and may be
37
Advertisement
Table of Contents
