Table of Contents
Advertisement
Figure 21. Removing and Replacing the Power Supply
To replace the power supply, reverse the removal procedure. Make sure to:
Align the power supply on the base of the chassis and inside the two tabs ( 8 in Figure 21).
Insert the EMI gasket 7 between the power supply and the drive.
To reduce radiated noise, perform five full (360° ) twists of the J1 power cable 3 .
With its locking features in a horizontal position, insert the power switch push button 6 into the front panel and press until it locks in
place.
Note: If the power switch does not work properly, loosen the power supply mounting screw 2 , slide the power supply to the rear of the
chassis, and retighten the mounting screw.
Arrange the cables so that they do not interfere with the cooling fan blades or the replacement of the cover. Ensure that they do not
obstruct airflow through the fan.
Note: The power supply connector J3 is not used in the 7208 Tape Drive.
7208 Tape Drive Service Guide
Removing and Replacing the Power Supply
All manuals and user guides at all-guides.com
¦ Copyright IBM Corp. 1998
4.4 - 2
Advertisement
Table of Contents
