Table of Contents
Advertisement
4.3 Removing and Replacing the Drive
To remove the drive from the 7208 Tape Drive:
1. Perform the cover removal procedure. Refer to "Removing and Replacing the Cover" in topic 4.2.
2. Tilt the 7208 Tape Drive on its side. Support the drive ( 1 in Figure 20) while removing the four screws 2 that secure the drive to the
chassis.
3. Support the drive while returning the 7208 Tape Drive to its original position.
4. Disconnect the power supply connector (J1) 3 from the drive.
5. Disconnect the internal SCSI bus cable 4 from the drive.
Note: To remove the cable, grasp the connector and pull it towards you. Do not pull on the cable.
6. Disconnect the internal SCSI address cable 5 from the drive.
7. Slide the drive forward and out of the chassis.
7208 Tape Drive Service Guide
Removing and Replacing the Drive
All manuals and user guides at all-guides.com
¦ Copyright IBM Corp. 1998
4.3 - 1
Advertisement
Table of Contents
