Table of Contents
Advertisement
Figure 3. Safety Inspection - Rear View of the 7208 Tape Drive Model 342
Note: Use an analog meter to measure grounding resistance; do not use a digital multimeter.
15. If the 7208 Tape Drive passes the test in the previous step, plug its external power cable into the electrical outlet. If the 7208 Tape
Drive does not pass the test, see Chapter 3, "Maintenance Analysis Procedures" in topic 3.0 for more information. If problems persist,
contact your service representative.
Note: Safety Information Label, Part Number 85F7884, located on top of the power supply under the top cover, shows the following
symbol:
This symbol indicates a hazard arising from dangerous voltage inside. Do not open.
7208 Tape Drive Service Guide
Safety Inspection Procedures
All manuals and user guides at all-guides.com
¦ Copyright IBM Corp. 1998
FRONT_1.3 - 4
Advertisement
Table of Contents
